08-21-2015, 10:59 PM
For the first time since September, I made some chips today. I have some of my machines reconditioned and back into the shop. When I was freeing up and cleaning the floor drill press, the table crank broke (plastic). I started turning the hub for a steel replacement today on the Storebro lathe. Man, does it feel good!
I might post a picture or two when I get it finished. I'll post the shop rebuild when I'm finally done. I moved back into my house on June 15, nine months after the fire.
I might post a picture or two when I get it finished. I'll post the shop rebuild when I'm finally done. I moved back into my house on June 15, nine months after the fire.
Mike
If you can't get one, make one.
Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
If you can't get one, make one.
Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.