(08-25-2015, 10:45 PM)Highpower Wrote:(08-24-2015, 04:43 PM)dallen Wrote: finally got a good pour on this in aluminum so now I can give it a shot again with cast iron
Nice molds David!
1 lb. ingots?
I haven't filled it with lead but I would think that its a 4 pound mold with break lines at 1 pound.
I have a couple ingots of printers type that were sent to me that were made in a 3 pound mold that made two 1 pound ingots and two .5 pound ones if you needed to break the block down for alloying.
now to go see how bad I melting things inside the furnace yesterday and how much repair I have to do.
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!