10-10-2016, 10:25 PM
Vinny and Mayhem,
On these machines, there are two screws that apply pressure to the gib in order to lock the Y-axis. As they come from the factory, you have to tighten both to lock the table. The two arms joined by the horizontal link turn both of the new bolts at the same time, applying locking pressure that is better than the original arrangement.
On these machines, there are two screws that apply pressure to the gib in order to lock the Y-axis. As they come from the factory, you have to tighten both to lock the table. The two arms joined by the horizontal link turn both of the new bolts at the same time, applying locking pressure that is better than the original arrangement.
Mike
If you can't get one, make one.
Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
If you can't get one, make one.
Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.