10-11-2016, 11:52 AM
I'm getting down on the old project list, so now I'm ticking off the little ones I've been leaving for some time. Yesterday, I finally got a stock support built for the horizontal bandsaw. I picked up a pair of small rollers at Restore last year and dug a 1" thick disk out of stock. That's as far as I got back then. Simple enough. Weld a small disk on a 3/4" nut, weld a piece of 3/4" pipe to the base, attach the roller to the threaded rod. Done and used twice already.
The second item off the list was a simple stop for the 6" vise I picked up last summer for the Victoria mill. The small block behind the stop is what I cut out with bandsaws to save a LOT of milling.
The second item off the list was a simple stop for the 6" vise I picked up last summer for the Victoria mill. The small block behind the stop is what I cut out with bandsaws to save a LOT of milling.
Mike
If you can't get one, make one.
Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
If you can't get one, make one.
Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.