11-20-2016, 11:29 AM
drilled the lever with a 1/4" bit, then counter bored it with a 11/16" endmill so I had a flat bottom hole, then I reamed it to 18 MM to fit the steel insert that was in the original lever. The original was pinned on to the shaft with a roll pin. I could of got away with not using the insert but didn't have a reamer to fit the shaft which is like 13 MM.
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough!
If life seems normal, your not going fast enough!