11-28-2016, 11:41 PM
Since my X2 CNC mill is finally rising from the ashes, as it were, I'm realizing that there are certain fittings that did not return to my custody after the fire. Today, I made up a bunch of T-nuts in both 1/4" and 3/8" for all of the necessary workholding tasks.
In the near future, I'll be making a pair of low-profile toe clamps and a clamping bar, as well as a replacement for my hot-wire attachment. I will likely use the attachment mainly for making forms to use in lost-foam casing.
In the near future, I'll be making a pair of low-profile toe clamps and a clamping bar, as well as a replacement for my hot-wire attachment. I will likely use the attachment mainly for making forms to use in lost-foam casing.
Mike
If you can't get one, make one.
Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
If you can't get one, make one.
Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.