08-02-2017, 09:04 PM
I made a plate to clamp in my Kurt vise for holding things that won't fit in the vise or need to be clamped down. I used it the other day to cut some blind dadoes in some cabinet sides. It's 3/4" thick 6061 that was left over from some fixture I no longer use. Measures 12"x17.5". I machined a groove in the bottom for some 5/8" CRS and bolted them together with 3/8-16 flatheads. I also drilled and tapped some 1/4-20 holes in the back for attaching side plates. I will likely drill and tap some holes in it to allow the use of toe clamps.