01-05-2018, 05:02 PM
I had the same issue with mounting the stop limit rail on my mill for the knee power feed. I just milled a chamfer along the back side of a piece of 1/4" thick aluminum flat stock so that it cleared the radius on the casting and sat flat on the the front edge. Then mounted the limit rail over the new 'filler' piece.
I don't think you'll miss that inch behind the table really. That's why you have a movable ram.
Did you install a stop bolt on the back side of the table saddle? My mill didn't come with a DRO but it did have a stop bolt already installed. I'm glad it was there though when I finally got around to buying the DRO though.
I don't think you'll miss that inch behind the table really. That's why you have a movable ram.
Did you install a stop bolt on the back side of the table saddle? My mill didn't come with a DRO but it did have a stop bolt already installed. I'm glad it was there though when I finally got around to buying the DRO though.
Willie