04-28-2018, 09:54 AM
I'm headed to Meijer in a bit to swap out the gloss stuff for flat. The 2X paint from rustoleum works great on this plastic. Perhaps I should paint before I do the post cure bake. That's what I did in the past.
Anyway, yeah. after the new boards show up I plan on going into production with them. The white one was the final test unit. The black ones were supposed to be the beginning of production. The new boards share the same screws that hold the boards currently in place, so no new machining is needed.
Anyway, yeah. after the new boards show up I plan on going into production with them. The white one was the final test unit. The black ones were supposed to be the beginning of production. The new boards share the same screws that hold the boards currently in place, so no new machining is needed.
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
the nobucks boutique etsy shop | the nobucks boutique
the nobucks boutique etsy shop | the nobucks boutique