Todays Project - What did you do today?
(05-23-2020, 12:12 PM)Dr Stan Wrote: What is the flat for?  Given it has a cotter pin hole for holding the nut on I cannot see any use for the flat.

Anti-rotation washer.

[Image: TAP994.jpg]
Willie
Reply
Thanks given by: Dr Stan
Ah says the grasshopper.
Reply
Thanks given by:
Yep. The bearing pushes up against it and if it turns it won't turn the nut and sheer the cotter pin.
Logan 200, Index 40H Mill, Boyer-Shultz 612 Surface Grinder, HF 4x6 Bandsaw, a shear with no name, ...
Reply
Thanks given by:
Something I made in the shop, just for grins:

   
Full of ideas, but slow to produce parts
Reply
Thanks given by:
If you made that over here you’d be eating three square meals a day curtsy of Her Majesty detained in one of her luxury long term secure hotels :)
Andrew Mawson, proud to be a member of MetalworkingFun Forum since Oct 2013.
Reply
Thanks given by:
It's PVC plastic, and doesn't fire anything. Full size model. Took me about 45-50 hours of intense effort to make it.
Full of ideas, but slow to produce parts
Reply
Thanks given by:
Soon to be seen next to a large sign out front that says:

SERIOUSLY... Get off my lawn! Big Grin
Willie
Reply
Thanks given by:
What I did today
   

   

   

   

   

   

   
Hopefully these have posted regards Stephen
Reply
Thanks given by:
Looks like a useful little anvil.👍
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:
Now its too pretty to use and ding up. Big Grin
Reply
Thanks given by:




Users browsing this thread: 8 Guest(s)