11-28-2023, 07:34 PM
(11-28-2023, 05:59 PM)EdK Wrote:(11-28-2023, 11:48 AM)Vinny Wrote: Any worry about the magnets flying off at high speed?
Plan B is to 3D print a thin ring that would slip over the magnets as they are now to contain them if necessary. The sensor has a working distance up to 5mm so plenty to work with.
Ed
Could you 3D print the entire collar with reverse counter bores? That way you could slip the magnets in from the inside of the collar and they would be held in by the reduced diameter at the O.D.
Willie