Making your own chamber reamers
#8
Then I marked all the diameter changes and turned the OD to within .010" at those points.
   

I turned all the straight tapers at this point. Then I offset the tailstock and turned the tapers.

   

Here it is all polished to size and ready for fluting.

   

Next I moved to the mill with my hex collet holder. I set it up with a stop so I could keep the flute lengths the same.

       
pamrick, proud to be a member of MetalworkingFun since Jul 2012.
Reply
Thanks given by:


Messages In This Thread
Making your own chamber reamers - by SnailPowered - 08-25-2012, 08:32 AM
RE: Making your own chamber reamers - by DaveH - 08-25-2012, 05:50 PM
RE: Making your own chamber reamers - by pamrick - 09-22-2012, 07:25 PM
RE: Making your own chamber reamers - by pamrick - 12-30-2012, 10:44 AM
RE: Making your own chamber reamers - by pamrick - 12-30-2012, 10:51 AM
RE: Making your own chamber reamers - by pamrick - 12-30-2012, 10:55 AM
RE: Making your own chamber reamers - by pamrick - 12-30-2012, 11:05 AM
RE: Making your own chamber reamers - by pamrick - 12-30-2012, 11:07 AM
RE: Making your own chamber reamers - by DaveH - 12-30-2012, 04:33 PM
RE: Making your own chamber reamers - by pamrick - 12-30-2012, 08:07 PM
RE: Making your own chamber reamers - by Mayhem - 12-31-2012, 08:28 AM
RE: Making your own chamber reamers - by pamrick - 12-31-2012, 09:34 PM
RE: Making your own chamber reamers - by Mayhem - 01-01-2013, 04:56 AM
RE: Making your own chamber reamers - by TomG - 01-02-2013, 12:01 AM
RE: Making your own chamber reamers - by pamrick - 01-02-2013, 09:24 PM



Users browsing this thread: 1 Guest(s)