Cutting Big Holes In Thin Metal
#21
(09-12-2012, 11:53 AM)DaveH Wrote:
(09-12-2012, 11:04 AM)Rickabilly Wrote: Oh and if you buy a thrust race either a ball style or needle roller style with a 10mm bore and use it under the nut that you are turning to close the punch into the die it reduces the torque required by a whole heap, well worth the investment.

Rick
Good tip Rick Thumbsup
Smiley-eatdrink004
DaveH

Hello Dave,

I wish I could take the credit for the idea, but Q Max sells the larger sizes complete with the bearing,
So, credit where it's due.

Regards
Rick
Whatever it is, do it today, Tomorrow may not be an option and regret outlasts fatigue.
Reply
Thanks given by:
#22
Quality rack there John, very neatWorthy:worthy and you now have to tool to make more Drool. Good that they fit direct into your draw too , will keep them nice and clean Big Grin
Just for anyone else thats interested I am sure you can get Qmax type cutters in square and other switch hole type shapes too.

cheers Mick
Micktoon, proud to be a member of MetalworkingFun since Sep 2012.
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)