Running a shaper - the compound
#3
no expert but I would say the built in rake on the tool holder is pulling you in to the work. tool bit should be standing straight up and down.

you can silver solder a bit into a hunk of square bar, or mill a slot in it them silver solder or weld a cap on top and installed a set screw to make a quick and sometimes fancy tool holder, get rectangular bits long enough to use with by themselves

As Mayhem said pictures always helpBig GrinBig Grin
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:


Messages In This Thread
RE: Running a shaper - the compound - by Mayhem - 09-04-2012, 08:35 AM
RE: Running a shaper - the compound - by dallen - 09-04-2012, 08:48 AM
RE: Running a shaper - the compound - by f350ca - 09-04-2012, 09:27 AM
RE: Running a shaper - the compound - by big job - 09-06-2012, 05:24 AM
RE: Running a shaper - the compound - by stevec - 09-06-2012, 06:38 AM
RE: Running a shaper - the compound - by big job - 09-07-2012, 05:03 AM
RE: Running a shaper - the compound - by stevec - 09-07-2012, 06:52 AM
RE: Running a shaper - the compound - by big job - 09-07-2012, 05:17 AM
RE: Running a shaper - the compound - by EdK - 09-07-2012, 05:33 AM
RE: Running a shaper - the compound - by big job - 09-07-2012, 06:29 AM
RE: Running a shaper - the compound - by stevec - 09-07-2012, 07:11 AM
RE: Running a shaper - the compound - by big job - 09-08-2012, 05:05 AM
RE: Running a shaper - the compound - by f350ca - 09-08-2012, 10:52 AM
RE: Running a shaper - the compound - by big job - 09-09-2012, 07:49 AM
RE: Running a shaper - the compound - by dallen - 09-09-2012, 08:50 AM
RE: Running a shaper - the compound - by f350ca - 09-09-2012, 10:44 AM
RE: Running a shaper - the compound - by f350ca - 09-09-2012, 09:45 PM
RE: Running a shaper - the compound - by f350ca - 09-11-2012, 10:37 PM
RE: Running a shaper - the compound - by EdK - 09-12-2012, 05:32 AM
RE: Running a shaper - the compound - by Mayhem - 09-12-2012, 05:54 AM
RE: Running a shaper - the compound - by big job - 09-14-2012, 05:57 AM
RE: Running a shaper - the compound - by stevec - 09-20-2012, 05:01 PM



Users browsing this thread: 1 Guest(s)