Running a shaper - the compound
#14
(09-07-2012, 05:03 AM)big job Wrote: Oh I forgot that pic thats where the die grinder goes into but I use an
end mill
Thanks for clearing that up Bj.
BTW I'm going to u-tube now to see if I can find that spiral knurling thing.
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:


Messages In This Thread
RE: Running a shaper - the compound - by Mayhem - 09-04-2012, 08:35 AM
RE: Running a shaper - the compound - by dallen - 09-04-2012, 08:48 AM
RE: Running a shaper - the compound - by f350ca - 09-04-2012, 09:27 AM
RE: Running a shaper - the compound - by big job - 09-06-2012, 05:24 AM
RE: Running a shaper - the compound - by stevec - 09-06-2012, 06:38 AM
RE: Running a shaper - the compound - by big job - 09-07-2012, 05:03 AM
RE: Running a shaper - the compound - by stevec - 09-07-2012, 06:52 AM
RE: Running a shaper - the compound - by big job - 09-07-2012, 05:17 AM
RE: Running a shaper - the compound - by EdK - 09-07-2012, 05:33 AM
RE: Running a shaper - the compound - by big job - 09-07-2012, 06:29 AM
RE: Running a shaper - the compound - by stevec - 09-07-2012, 07:11 AM
RE: Running a shaper - the compound - by big job - 09-08-2012, 05:05 AM
RE: Running a shaper - the compound - by f350ca - 09-08-2012, 10:52 AM
RE: Running a shaper - the compound - by big job - 09-09-2012, 07:49 AM
RE: Running a shaper - the compound - by dallen - 09-09-2012, 08:50 AM
RE: Running a shaper - the compound - by f350ca - 09-09-2012, 10:44 AM
RE: Running a shaper - the compound - by f350ca - 09-09-2012, 09:45 PM
RE: Running a shaper - the compound - by f350ca - 09-11-2012, 10:37 PM
RE: Running a shaper - the compound - by EdK - 09-12-2012, 05:32 AM
RE: Running a shaper - the compound - by Mayhem - 09-12-2012, 05:54 AM
RE: Running a shaper - the compound - by big job - 09-14-2012, 05:57 AM
RE: Running a shaper - the compound - by stevec - 09-20-2012, 05:01 PM



Users browsing this thread: 2 Guest(s)