Where did you mount your vise?
#6
rleete, Usually a mill table gets loose in the middle where most of the action occurs is there something about the mini mill that's different?
I had the vise on one side and the rotab on the other for a while but found that Murphy's law rules and you've gotta take one or the other of to clear some job.
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:


Messages In This Thread
Where did you mount your vise? - by Wawoodman - 09-19-2012, 10:32 AM
RE: Where did you mount your vise? - by EdK - 09-19-2012, 10:50 AM
RE: Where did you mount your vise? - by dallen - 09-19-2012, 11:44 AM
RE: Where did you mount your vise? - by rleete - 09-19-2012, 12:14 PM
RE: Where did you mount your vise? - by Wawoodman - 09-19-2012, 01:15 PM
RE: Where did you mount your vise? - by stevec - 09-19-2012, 01:35 PM
RE: Where did you mount your vise? - by rleete - 09-19-2012, 06:10 PM
RE: Where did you mount your vise? - by sasquatch - 09-19-2012, 06:26 PM
RE: Where did you mount your vise? - by wrustle - 10-03-2012, 06:31 PM



Users browsing this thread: 2 Guest(s)