|
Flat wrenches
|
09-26-2012, 02:25 PM
(09-26-2012, 12:19 PM)Wawoodman Wrote: ...Ed, how did you do the big outside radius? Did you mill it square, and grind/file to shape? Mike, I milled most of the large radius by turning the vise a bit at a time to get the majority of the steel removed. Then I used Bob's (krv3000) method of filing it to shape. Since it wasn't a critical dimension, I wasn't too fussy about getting the radius exact. Ed |
|
« Next Oldest | Next Newest »
|
| Messages In This Thread |
|
Flat wrenches - by Wawoodman - 09-26-2012, 09:11 AM
RE: Flat wrenches - by EdK - 09-26-2012, 09:54 AM
RE: Flat wrenches - by dallen - 09-26-2012, 10:16 AM
RE: Flat wrenches - by Wawoodman - 09-26-2012, 12:19 PM
RE: Flat wrenches - by EdK - 09-26-2012, 02:25 PM
RE: Flat wrenches - by dallen - 09-26-2012, 12:52 PM
RE: Flat wrenches - by Wawoodman - 09-26-2012, 03:26 PM
RE: Flat wrenches - by EdK - 09-26-2012, 05:26 PM
RE: Flat wrenches - by TomG - 09-26-2012, 09:30 PM
RE: Flat wrenches - by Wawoodman - 09-27-2012, 09:32 AM
RE: Flat wrenches - by TomG - 09-27-2012, 10:02 AM
RE: Flat wrenches - by stevec - 09-27-2012, 07:10 AM
RE: Flat wrenches - by EdK - 09-27-2012, 07:19 AM
RE: Flat wrenches - by SnailPowered - 09-27-2012, 11:13 AM
RE: Flat wrenches - by EdK - 09-27-2012, 11:24 AM
RE: Flat wrenches - by SnailPowered - 09-27-2012, 11:40 AM
RE: Flat wrenches - by EdK - 09-27-2012, 11:51 AM
RE: Flat wrenches - by dallen - 09-27-2012, 11:55 AM
RE: Flat wrenches - by EdK - 09-27-2012, 11:57 AM
RE: Flat wrenches - by SnailPowered - 09-27-2012, 12:10 PM
|
