more stuff
#1
Here are some more things Ive made.
Parts washer, I had a shop brake the 16ga sheet metal "tub" and also the top. They sheared the end caps and I welded it together about 15 years ago. It has a pump in the tub with a manifold I made so you can use just the straight fluid, or one with fluid going through a brush. I used Loc Line for the line from the manifold. It also has a spin on filter to help keep the fluid clean, filter is from Napa and I think it is a diesel truck fuel filter if I remember right.
[Image: photobucket-1157-1350952456207.jpg]
New base for my Craftsman drill press, made of 2"x3"x 3/16" tube with 1" flat stock on the top, two pieces welder together and ground smooth. Its what I had lying around so thats why I used it lol.
[Image: photobucket-11388-1350952419124.jpg]
[Image: photobucket-2593-1350952398160.jpg]
Next is a stock rack, also made about 15 years ago. I have 3 more sections that are in storage with the rest of my equipment. After the divorce I am finally starting to be able to work again. I have a small shop that I rent, so room is tight. Hopefully soon I can bring some more of my equipment down.
[Image: photobucket-15107-1350952433858.jpg]
Hanger for the creeper
[Image: photobucket-3719-1329949193565.jpg]
[Image: photobucket-5997-1329949402319.jpg]
monkers, proud to be a member of MetalworkingFun since Nov 2012.
Reply
Thanks given by:
#2
Great bunch of photos and great nicely done projects!!

Thanks for posting these.
sasquatch, proud to be a member of MetalworkingFun since Jul 2012.
Reply
Thanks given by:
#3
Thank you!
monkers, proud to be a member of MetalworkingFun since Nov 2012.
Reply
Thanks given by:
#4
Craig,
Very nice, I especially like the base you made for the drill press Thumbsup Worthy
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#5
Lol thank you!! Its rugged haha
monkers, proud to be a member of MetalworkingFun since Nov 2012.
Reply
Thanks given by:
#6
Great looking projects Craig,
Oh and Welcome to the forum, glad to have you on board.Smiley-eatdrink004

Jerry.Popcorn
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#7
Thank you!
monkers, proud to be a member of MetalworkingFun since Nov 2012.
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)