How to Mill a Part That is Too Thin to Mill
#11
Thanks Mike.

Don't know about you, but my old memory box keeps getting smaller every day. Maybe that's why I feel the need lately to make these videos. 17428

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:
#12
Tom,
just kidding you a little.... Another way to get the job done with what you have on hand is good! one of my old tag lines was more than one way to skin a cat or door (that's a teeny bit of sheet metal humour)
oldgoaly, proud to be a member of MetalworkingFun Forum since Jun 2013.
Reply
Thanks given by:
#13
(07-22-2013, 07:32 AM)oldgoaly Wrote: Tom,
just kidding you a little.... Another way to get the job done with what you have on hand is good! one of my old tag lines was more than one way to skin a cat or door (that's a teeny bit of sheet metal humour)

Sheet metal humor? Does that mean it's getting a bit thin? RotflRotflRotfl

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:
#14
The golden rule of sheet metal humour is to allow yourself to bent into shape but never bent out of shape over anything!
oldgoaly, proud to be a member of MetalworkingFun Forum since Jun 2013.
Reply
Thanks given by:
#15
"I'm feeling a little reckless today"

You do like to live life on the edge Tom Big Grin

Nice tip - thanks for showing. I wouldn't have thought of doing that in a million years. I figured you would need a surface grinder to tackle something that thin.
Hunting American dentists since 2015.
Reply
Thanks given by:
#16
Thanks Darren.

That actually was the first time that I tried milling something that thin, so there was potential for an outtake. Slaphead

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:
#17
Tom,
I have never seen that before, Smiley-signs107
Like Ed, I don't climb mill on my machine - unless it is just a couple of thou.

Sorry Tom but to climb mill on small bench type milling machines like Ed's and the one I have is going to end in tears and a disaster.
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#18
(07-22-2013, 12:57 PM)DaveH Wrote: Tom,
I have never seen that before, Smiley-signs107
Like Ed, I don't climb mill on my machine - unless it is just a couple of thou.

Sorry Tom but to climb mill on small bench type milling machines like Ed's and the one I have is going to end in tears and a disaster.
Smiley-eatdrink004
DaveH

There is always a way.

You could skip the sawing step and mill the whole thing, leaving a few thousandths for a finish climb cut. You could also try roughing it out by conventional milling and then finish by climbing the last few thousandths. If you noticed in the video, after the first cut I made I returned to the start without retracting the cutter. It was conventional milling then and it didn't seem to lift the part.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by: EdK
#19
Hi
Tom
Very well shown Smiley-eatdrink004Smiley-eatdrink004Smiley-eatdrink004Smiley-eatdrink004
John
Reply
Thanks given by:
#20
Thanks John.
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)