Fixing a Leaky RF-45 Mill Head - Enco
A question Ed, if you don't mind what did it cost you to rebuild the head. I don't plan on tearing mine down its not leaking but may look into gathering up the parts to have on hand for a rainy day project to put in a better grade of bearings, and then you never know it may crap out tomorrow and need rebuilding.
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:
(09-17-2012, 08:42 AM)dallen Wrote: A question Ed, if you don't mind what did it cost you to rebuild the head. I don't plan on tearing mine down its not leaking but may look into gathering up the parts to have on hand for a rainy day project to put in a better grade of bearings, and then you never know it may crap out tomorrow and need rebuilding.

DA,

I'm guessing it was around $300. You wouldn't need to replace all of the bearings like I did. All of the smaller bearings seemed to be in good shape and there are a lot of them. Hope this helps.

Ed
Reply
Thanks given by:




Users browsing this thread: 3 Guest(s)