Let's See Your Mill
#21
John,

626 a very useful milling machine.Smile

Did you make the 'rise block' that's a handy addition.

And the motor single phase, 3 phase?
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#22
Nice looking mill John. I bet that riser does come in handy. Interesting way to store your angle block!
Hunting American dentists since 2015.
Reply
Thanks given by:
#23
(02-25-2012, 02:51 PM)DaveH Wrote: John,

626 a very useful milling machine.Smile

Did you make the 'rise block' that's a handy addition.

And the motor single phase, 3 phase?
Smiley-eatdrink004
DaveH

Dave
The mill is single phase
The riser block was made by me
It has made a massiv differance to the machine
Reply
Thanks given by:
#24
(02-25-2012, 08:30 PM)Mayhem Wrote: Nice looking mill John. I bet that riser does come in handy. Interesting way to store your angle block!

SlapheadSlaphead
The angle block is stored in a safe place now Big GrinBig GrinBig GrinBig Grin
John

Reply
Thanks given by:
#25
John,

I would love to fit a riser to my 836, to give me a little more throat when I use my dividing head in the upright position, but my ceiling is only just above the motor top. In fact, I have to tilt the head to nearly level just to get the drawbar out.

It was on the cards for me to buy one of those 626's, until someone offered to put some extra cash to what I had, to purchase the next sized mill up. They really are a good all round machine for the price.


John
Reply
Thanks given by:
#26
Here's my Enco clone just after mounting it on the stand.
   
Collecting tools for 30 years.
Reply
Thanks given by:
#27
Dan,

Nice stand you've made for your mill. I used those same leveling feet for my lathe. They work very well. For my mill, I made my own using hockey pucks and carriage bolts.

Ed
Reply
Thanks given by:
#28
Dan,

Nice mill, your lathe looks similar to mine (and a few others on here) Smile

A very clean workshop Tongue
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#29
(04-05-2012, 10:04 AM)DaveH Wrote: A very clean workshop Tongue
Smiley-eatdrink004
DaveH

And BIG! I would kill to have that kind of space to work in. Drool

Nice job on the mill stand. It certainly looks sturdy enough and then some. Good color match too.
Willie
Reply
Thanks given by:
#30
Thanks.
The lathe is also from Enco, purchased in Feb. I had the paint color matched for both pieces of equipment and painted them myself. The mill stand is 2x2x.120" tubing with 1/4" plate for the top and shelf's. It weighs 300lbs which makes the mill very stable with the wider footprint. I modified the lathe stand to beef it up and used the same feet. I will post up pictures on each build in the welding section.

Dan
Collecting tools for 30 years.
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)