Making A Welding Table
#51
(09-24-2013, 03:03 AM)DaveH Wrote: Here's my heavy duty table. Has a 3 ton arbor press sitting on it at the moment.


It is not just the static load -what happens when it is moved about.
Smiley-eatdrink004
DaveH

Nice table Dave. What size is it?

Ed
Reply
Thanks given by:
#52
Ed,
(1250mm x 660mm) 49" x 26" I was given the top piece of steel so that governed the size. The thickness of the steel top is 8mm (.315")
Similar in size to yours Ed, (even the colour Rotfl)
The steel tube is all 1.5" x 14 gauge.
Smiley-eatdrink004
DaveH
Reply
Thanks given by: EdK
#53
OK Dave, how about this version. All 2" 14 gauge tubing but added 1/8" thick gussets.

Ed

   
Reply
Thanks given by:
#54
(09-24-2013, 05:12 PM)EdK Wrote: OK Dave, how about this version. All 2" 14 gauge tubing but added 1/8" thick gussets.

Ed
You should be doing the disign work on ships hulls YikesYikesYikesYikes
Reply
Thanks given by:
#55
Ed, wait! what are you planning for gusset support?
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:
#56
(09-24-2013, 05:38 PM)doubleboost Wrote:
(09-24-2013, 05:12 PM)EdK Wrote: OK Dave, how about this version. All 2" 14 gauge tubing but added 1/8" thick gussets.

Ed
You should be doing the disign work on ships hulls YikesYikesYikesYikes

Rotfl
Reply
Thanks given by:
#57
(09-23-2013, 05:20 PM)EdK Wrote:
(09-23-2013, 11:50 AM)stevec Wrote: Ed, I don't think the "doubling" of the front rails nor the 45° bracing are at all necessary.
But then I don't know the Tonnage of capacity required..
...

Steve,

I'm thinking the same. After all we're talking about only a couple of hundred pounds of load distributed over the frame. 17428

Ed
I'm just thinking about the sensibility of the above...17428
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:
#58
(09-24-2013, 06:05 PM)stevec Wrote: Ed, wait! what are you planning for gusset support?

Hell, I don't know. The tubes they're welded to? What am I doing wrong? 17428

Ed
Reply
Thanks given by:
#59
Sorry Ed, I was just playin with ya. I thought things were pretty well settled with post #42.
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:
#60
No problem Steve. You were right, too much information is almost as bad as not enough. I'm going without the gussets. If the table feels wobbly I'll add some gussets. This design is done for now. Sweat

Ed
Reply
Thanks given by:




Users browsing this thread: 2 Guest(s)