Cutting Speed and RPM on the Lathe and Mill
#11
Well done, Tom. I wrote down your formulas and will print a chart to hang in my shop.

Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
Reply
Thanks given by:
#12
(10-01-2013, 10:26 AM)TomG Wrote: at some point eyes start to glaze over. Blink
I'm gonna put masking tape over the little camera at the top of my laptop's screen. Rolleyes
Rotfl
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:
#13
There's more truth to that than you might imagine Steve. Yikes
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:
#14
I was surprised you didn't break that 1/8" end mill climb milling. Yikes

My balls must be made of that sissy steel. Chin

Ed
Reply
Thanks given by:
#15
I climb mill most of the time Ed. I'd rather have the end mill deflect away from the part than deflect into it and cut too deep. I break one once in a while, but not very often.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by: EdK
#16
When I bought my mill I was so green I was afraid to go out in a field in case the cows would eat me. I cut the same as if i was using a router which I later discovered was climb milling. If you cut conventionally with a router the cuter tears the material causing splintering.
Oh this is bad so I read, as a result I tried conventional milling as much as possible. The surface finish sucked and the machine seamed to be hammering more than cutting.
With some experience comes confidence or absolute recklessness, like Tom I'm a back to being closet climb cutter.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:
#17
The reason conventional milling creates such a crappy finish is that the cutting edge drags on the work before enough pressure is produced for it to cut. When climb milling, as soon as the cutting edge hits the work, it's cutting, there's no dragging at all.

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:
#18
So what's next Tom? Feed rates, depth of cut...
Hunting American dentists since 2015.
Reply
Thanks given by:
#19
Darren,

I'm debating the value of a feed rate video for the hobby machinist. I can show how to calculate the feed rate based on chip load and rpm, but most powered feeds on home machines are either variable or non-existent. I can't remember the last time I calculated a feed rate and then actually applied it. It's more "that sounds about right" or "the color of the chips is good".

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:
#20
Wow, an HP calculator and RPN to calculate RPM.

That is the second time this month I've seen an old HP.
Reply
Thanks given by:




Users browsing this thread: 2 Guest(s)