MetalworkingFun Forum › Machining › General Metalworking Discussion v
ceilingtrains running New Years Eve 2013

Thread Modes
ceilingtrains running New Years Eve 2013
aametalmaster Offline
MTLMSTR
****
Posts: 410
Threads: 77
Joined: Mar 2012
Location: Salem, Ohio
The following 1 user Likes aametalmaster's post:
Sandia (01-05-2014)
#1
01-01-2014, 08:30 PM (This post was last modified: 01-01-2014, 08:39 PM by aametalmaster.)
Here is my number 14 and 15 ceilingtrain running again this New Years Eve as it has for the last 6...Bob
http://www.youtube.com/watch?v=IzYBj8ffi...e=youtu.be
Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...
Reply
Thanks given by:
Arbalest Offline
Sophmore
***
Posts: 175
Threads: 4
Joined: Sep 2012
Location: Dorset, UK
The following 1 user Likes Arbalest's post:
aametalmaster (01-02-2014)
#2
01-02-2014, 05:55 AM
Very nice!
Arbalest, proud to be a member of MetalworkingFun since Sep 2012.
Reply
Thanks given by: aametalmaster
DaveH Offline
Child of the 60's
******
Posts: 4,513
Threads: 139
Joined: Feb 2012
Location: Kempton Park. South Africa
The following 1 user Likes DaveH's post:
aametalmaster (01-02-2014)
#3
01-02-2014, 02:30 PM
Bob,
Always liked it Thumbsup
Smiley-eatdrink004
DaveH
Reply
Thanks given by: aametalmaster
PixMan Offline
Resident Pariah
******
Posts: 2,344
Threads: 53
Joined: Feb 2012
Location: Spencer MA USA
#4
01-03-2014, 08:47 PM
What gauge trains do they run there? I used to have a 4' x 8' HO gauge setup, didn't sell it off until I was about 38 years old and I got it when I was 14. It was built by my cousin when he was about the same age, and he's got 8 years on me.
Reply
Thanks given by:
aametalmaster Offline
MTLMSTR
****
Posts: 410
Threads: 77
Joined: Mar 2012
Location: Salem, Ohio
#5
01-04-2014, 05:46 AM
(01-03-2014, 08:47 PM)PixMan Wrote: What gauge trains do they run there?
I use the 3 rail O Gauge track for the bridges...Bob
Bob Wright
Metal Master Fab
Salem Ohio
Birthplace of the Silver and Deming drill bit.
5 Lathes, SBL Shaper, Lewis Mill, 7 drill presses, 5 welders...
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)