Dual flight controls for simulator
#71
Man. That's an inspiring thought.
Mike

If you can't get one, make one.

Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by:
#72
Pretty happy with the press fit bearing holes I bored today. The axle is a tight sliding fit in both bearings, had to use sandpaper to hit the mark but at least I didn't go past.

[Image: image.jpg]
Shawn, proud to be a member of MetalworkingFun Forum since Nov 2013.
Reply
Thanks given by:
#73
Nice work Shawn, very nice Smiley-signs107 
Smiley-eatdrink004 
DaveH
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)