32x40 H Gas Engine
#11
It's in there...somewhere. That looks like a lot of potential chips Brian. Applaud

Tom
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:
#12
Brian, I'm not nitpicking here, but, by "iron" do you mean what we "Americans" call steel? Or are they in fact cast iron?
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:
#13
Do you mean like aluminum vs. aluminium?
[Image: TomsTechLogo-Profile.png]
Reply
Thanks given by:
#14
Hi Steve .
Don't worry about the question's that's why we have a Forum.

The material is Meehanite iron made in continuously cast bar It has no blow holes or inclusions,, Good quality iron.
Looking forward to the next question.
Brian.
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com Welcome
Reply
Thanks given by: stevec
#15
same as Durabar its a continuous cast Iron that is beautiful to work with.
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.

If life seems normal, your not going fast enough! Tongue
Reply
Thanks given by:
#16
Well Lads the first chips are flying,
As I do not have a reliable mill vice I used my dividing head to provide a vertical plane and 3-2-1- blocks to keep things square.
The first job was to shape up the material for the cyl head.
   
After getting it square I reduced the area underneath so the real work could be done at a later date.
   
The next job will be to rough out the piston and liner blanks.
Dirty stuff this iron, Chips fly everywhere.
Brian Smiley-dancenana
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com Welcome
Reply
Thanks given by:
#17
ThumbsupThumbsup this is gowing to be good
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#18
(04-16-2014, 03:45 PM)krv3000 Wrote: ThumbsupThumbsup this is gowing to be good

I agree Bob. This is going to be a good one. Happyyes

Ed
Reply
Thanks given by:
#19
Smiley-signs064
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#20
So it's on to the next part.
I set up the material for the liner and piston in the lathe, and turned it down to near the size required for the liner then reduced the end for the piston.

   

I am uncertain as to whether I will use the liner as a chucking piece while i make the piston or mount the piston blank on a spigot In my ER collet??

We have visitors coming for Easter so work will come to a halt for a few days
Brian.Smiley-dancenana
Brian, proud to be a member of MetalworkingFun since Sep 2012.
http://briansworkshop.weebly.com Welcome
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)