Toolholder
#1
I had a little time at work today so I made an indexable flycutter tool holder.


Attached Files Thumbnail(s)
       
kcraig514, proud to be a member of MetalworkingFun Forum since Feb 2014.
Reply
Thanks given by:
#2
Nicely done. That looks like it will be a very useful tool.
JScott, proud to be a member of MetalworkingFun Forum since Mar 2014.
Reply
Thanks given by:
#3
I made one a while back. Works well.

[Image: IMGP1761_zps1d85c3ff.jpg]
Arbalest, proud to be a member of MetalworkingFun since Sep 2012.
Reply
Thanks given by:
#4
Very nice, Arbalest! I like that!

Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
Reply
Thanks given by:
#5
Looks good! I like the round insert.
kcraig514, proud to be a member of MetalworkingFun Forum since Feb 2014.
Reply
Thanks given by:
#6
You get lots of use from a round insert, just rotate a little to present a fresh edge when it dulls.
Arbalest, proud to be a member of MetalworkingFun since Sep 2012.
Reply
Thanks given by:




Users browsing this thread: 2 Guest(s)