Edge Finder Disassembly
#21
If easy dis-assembly is Your goal, just "bump" a part too hard when "finding" it in Your mill vise. Finding the spring and reassembling it is another matter.
mcostello, proud to be a member of MetalworkingFun Forum since Jul 2014.
Reply
Thanks given by:
#22
Hi All,

I thought you might like to see my center finder.  Its one that I made recently from a bit of scrap and a cheap (Aldi) laser pointer.
   

This picture shows the dimensions I used, but its not at all critical.  I used an angle of 10 degrees, but if you want to focus more closely to the work then 15 degrees would be better.

   
Best Regards:
Baron.

A member of MetalworkingFun Forum since Jul 2014.
Reply
Thanks given by:




Users browsing this thread: 2 Guest(s)