Project X Power Feed
#31
(02-01-2015, 08:42 PM)dallen Wrote: you could turn those two around

Yup, I see that now. Too late, I'm done with that feature but I'll remember that next time, I think.
Thanks for the tip.

Ed
Reply
Thanks given by:
#32
(02-01-2015, 08:42 PM)dallen Wrote: you could turn those two around

That's what I do in such a case. Works fine.
Reply
Thanks given by:
#33
You could eat off that lathe Ed! Nice work.
Hunting American dentists since 2015.
Reply
Thanks given by: EdK
#34
It's coming along slow but sure.

Ed

         


   
Reply
Thanks given by:
#35
What type of lubrication should be used with this needle bearing? I'm assuming grease since re-lubing it would mean removing the power feed from the mill table.

Ed

   
Reply
Thanks given by:
#36
I used Lubriplate (white lithium grease) on mine Ed. Coat the bevel gears with it too.
Willie
Reply
Thanks given by: EdK
#37
(02-08-2015, 03:53 PM)Highpower Wrote: I used Lubriplate (white lithium grease) on mine Ed. Coat the bevel gears with it too.

Good, I have a tube of that and was going to use it. Smile

Ed
Reply
Thanks given by:
#38
Looking good Ed
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by: EdK
#39
Very nice work Ed Thumbsup Smiley-signs107

Smiley-eatdrink004 
DaveH
Reply
Thanks given by: EdK
#40
Looking great Ed!

Being far too anal, I would run around the big square piece with a corner rounding cutter to smooth it out. Then I'd be at it with my ScotchBrite wheel to make it look more like a casting. I might even look for an anodizer to get it some cool color.
Reply
Thanks given by: EdK




Users browsing this thread: 1 Guest(s)