Help Centering on a rotary table
#11
Never thought of the plug thingy, I love learning from the pros, almost don't have to engage the grey matter at all with guys like you around?
Shawn, proud to be a member of MetalworkingFun Forum since Nov 2013.
Reply
Thanks given by:
#12
I would just clamp a piece of metal in the rotary table. that is bigger than the piece you are gonna mill o-ring groove on. Then clean it up in the mill and mill a pocket while turning the rotary table. make a snug fit pocket to hold you piece and make four holes, thread them up and bolt your piece to the piece in the rotary table. Then you would be in center on every piece until you remove the big piece from the rotary table
Reply
Thanks given by:
#13
I've used the "plug" method that Tony talked about for when I'm not too focused on being "perfect".  When I want to be extra sure I use my Blake co-ax indicator.

[Image: Blakeco-ax.gif]

http://www.blakemanufacturing.com/pages/aboutus.html


-Ron
11" South Bend lathe - Wells-Index 860C mill - 16" Queen City Shaper
Reply
Thanks given by:




Users browsing this thread: 2 Guest(s)