toys for the boys
#1
hi I picked these up at a boot sale. A toy motor and a mamod hammer. The motor was stripped and given a good clean and it runs well on 6 volt. The hammer the brace was bent. Straightened that out the pulley was held on by a brass screw which the head had come off. I tried to remove it but with no luck so I just filed it down to blend in to the pulley then I drilled and tapped M2 to fit a grub screw right pics.

       

       

       

       
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#2
Bob,
The hammer did come up nice - smart Smiley-signs107,

Just have to paint the motor now Big GrinBig GrinBig Grin

Smiley-eatdrink004
DaveH
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)