Lathe/mill adjustable feet pictures
#1
Hi,

There made from materials I had on hand. I started out with only making 6 for the lathe because I have just finished moving it, and can't bolt it down were it is. Then I decided to make the 4 for the mill and 4 for the shaper while I had the lathe set up to do them, and saves doing them latter.
They are made from 50mm mild steel I had, cut to around 25mm in length on the band saw, with a 14mm hole drilled in the centre on the lathe then shaped up to what I thought looked good.
I cut up some old chemset thread rod that I had as well. That why 6 have a hex in the end.
The thread rod is metric 16x2mm machined down to 14mm dia on one end, 15mm long. I used the vise to press them together and then plug welded them from the bottom.
The machined recess on the sides were the black is, is only to give the look of factory machine mounts, that are made of two pieces. For a lathe your better off with solid mounts to stop movement after it's leveled.
The last picture shows were the feet will go on the extension bases I made when I got the lathe, the Chinese just don't make these lathe stands high enough for us Aussies. I made the extensions out of 75x75x4mm square tube cut down the middle to make C sections.
Dave


Attached Files Thumbnail(s)
                   
Reply
Thanks given by:
#2
Nice work Dave.

When I get my lathe up to my workshop at home, I am going to pour a slab on top of the existing floor to raise her up. At the moment, I am stooping to operate the carriage hand wheel and half nuts.
Hunting American dentists since 2015.
Reply
Thanks given by:
#3
Dave,

Nicely made Smiley-signs107

I think it is always nice to be able to level the stand Thumbsup
Smiley-eatdrink004
DaveH
Reply
Thanks given by:




Users browsing this thread: 2 Guest(s)