Mill Vice Stop
#11
(05-18-2012, 05:10 PM)RobWilson Wrote: Smiley-signs107 is that the DRO bracket your cutting up RotflRotfl

Rob

Good one Rob. Rotfl

Ed
Reply
Thanks given by:
#12
No
Mate it is the motor mount of that old Drummond lathe
RotflRotflRotflRotfl
I was suprised as to how shiney it is on the insideDroolDrool
I will have to get you to photograph it , to reach its full potential
Big GrinBig GrinBig Grin679967996799
John
Reply
Thanks given by:
#13
RotflRotflRotflRotflRotfl not that quality lathe that you made me dig out of a barn Slaphead

That bit bar was the best part RotflRotflRotflRotfl

I will lend you my camera ,,,,,,,, see if it works for you Popcorn


Rob
Reply
Thanks given by:
#14
Drumond Lathe? Any pics? Round bed?
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:
#15
(05-18-2012, 07:58 PM)stevec Wrote: Drumond Lathe? Any pics? Round bed?

http://www.metalworkingfun.com/showthrea...94#pid4294
There you go
John
Reply
Thanks given by:
#16
Hi
I finished my vice stop today
Just some drilling and tapping
It seems to be fairly robustSmiley-dancenanaSmiley-dancenana
[Image: P5190046.jpg]
[Image: P5190045.jpg]
[Image: P5190042.jpg]
[Image: P5190049.jpg]
[Image: P5190051.jpg]
John
Reply
Thanks given by:
#17
John,

That is very smart, nice design Smiley-signs107

Nicely shown as well Thumbsup
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#18
John,

Another one to cross off your project list. Big Grin

Ed
Reply
Thanks given by:
#19
Suppose it will do mate RotflRotflRotflRotflRotfl

now stop frigging about a build that mill engine Thumbsup

Smiley-signs107 Rob
Reply
Thanks given by:
#20
OK
As long as you lend me your camera for the build log
RotflRotflRotflRotflRotflRotfl
John
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)