X Power Feed
#21
Have you found a motor that is suitable for less than the cost of the mill itself?
Full of ideas, but slow to produce parts
Reply
Thanks given by:
#22
(03-22-2024, 06:18 AM)rleete Wrote: Have you found a motor that is suitable for less than the cost of the mill itself?

Not yet, but I haven't looked much recently. I need to get back to this.

Ed
Reply
Thanks given by:
#23
I'm pretty sure I've found a solution, but I want to wait for the roads to clear up a bit before heading out.
Full of ideas, but slow to produce parts
Reply
Thanks given by: EdK




Users browsing this thread: 4 Guest(s)