Making a steady rest
#1
My lathe was made around the turn of the 20th Century and never came with a steady rest. So I thought I would make one. Given that my lathe has an 18" swing over the bed, I decided to make a steady rest of suitable stature!

Rather than attempt to turn up the body, I decided to get it cut from 1/2" plate. My design calls for 3 plates. This allows the middle plate to be cut differently to the outer two, forming both the hinge point and also the bolt hole for the clamp bar. Additionally, this approach allows the base to be incorporated in the design.

The outer plates have a series of holes, whilst the middle plate does not. These holes will allow the outer plates to be welded to the inner plate. By using an odd number of plates, warping will be minimised.

Here is one of the outer plates and the inner plate:
   

At this stage I am thinking of changing my initial design of having the basic style fingers with roller bearings and going with telescopic ones. If I stick with the original idea, I will simply mill a slot for them to run in. If I go telescopic I will add some bolsters and then drill holes for them.
Hunting American dentists since 2015.
Reply
Thanks given by:
#2
This is going to be good.... Drool
Willie
Reply
Thanks given by:
#3
ooo as wating
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#4
How were the plates cut, cnc plasma?
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:
#5
Mayhem,

Great! Thumbsup
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#6
Interesting ,,,,, i will be taking note as i my CUB lathe has no steady s Big Grin


Rob Thumbsup
Reply
Thanks given by:
#7
I'm all eyes looking forward to a great fab project!! Drool

Mayhem, keep those post and pics coming!Thumbsup

Jerry.Popcorn
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#8
68206820

Ed
Reply
Thanks given by:
#9
Thanks guys.

Steve - the plates were laser cut. A family friend works for a place and got them done cheap. Same place cut the top for my welding table (that they are sitting on in the pics). The table top was free though :)
Hunting American dentists since 2015.
Reply
Thanks given by:
#10
Some family friends are good to have, some maybe not.Rotfl
Looking good! I'll be following this project with interest.
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:




Users browsing this thread: 2 Guest(s)