Wire clamp tool...
#21
Ok... so here is the picture, One short piece of steel tubing, the nose piece is a short piece of steel turned with .003 PF in the tube ID then turner the taper. The nut, spring pins and threaded rod is junk I had dragging around. Like I said: fun project, cost nothing and it,s a usefull tool. I also added the first three samples of my test.
ClaudeF


Attached Files Thumbnail(s)
               
claudef, proud to be a member of Metalworking Forum since Mar 2012.
Reply
Thanks given by:
#22
(08-16-2012, 07:09 AM)claudef Wrote: Ok... so here is the picture, One short piece of steel tubing, the nose piece is a short piece of steel turned with .003 PF in the tube ID then turner the taper. The nut, spring pins and threaded rod is junk I had dragging around. Like I said: fun project, cost nothing and it,s a usefull tool. I also added the first three samples of my test.
ClaudeF

Applaud

It sure looks like it works well. Tight and tidy clamps. Smiley-signs107
Willie
Reply
Thanks given by:
#23
ClaudeF,

Nicely made tool Smiley-signs107
Looks like it's works very well too Thumbsup
Smiley-eatdrink004
DaveH
Reply
Thanks given by:




Users browsing this thread: 2 Guest(s)