Latest Delivery
You're a good man, Ed.

I also have a ROC 1-6" set of mics, and with every gauge block I've tested them against the mics have been spot on. While, yes, it would be just lovely to have some nice brand name mics, These work great.
Reply
Thanks given by: EdK
I forgot I had ordered this off of Amazon with free shipping from Japan. It came in the post today.

Ed

   
Reply
Thanks given by:
This could actually go in a few places: latest delivery, what did you do today, etc.

I have a two axis Shooting Star DRO on my mill, but I wanted something for the quill. So I ordered the iGaging setup, and it showed up yesterday.

Spent a few hours figuring out and fabbing the brackets, but it's there, and it works!

[Image: IMG_0658.jpg][Image: IMG_0662.jpg]
Mike

SB 10K (1976) Rockwell vertical mill (1967) Rockwell 17" drill press (1946) Me (1949)
Reply
Thanks given by:
Evening Lads  Big Grin

Just arrived today  a wee Variac , 0 to 270v  Smiley-dancenana


[Image: P1100431_zpsvrv8xjgw.jpg]
[Image: P1100432_zpsvlfs43ge.jpg]

and it does what it says on the tin .

[Image: P1100429_zps8vtqgmf7.jpg]
[Image: P1100428_zps8bzbqeve.jpg]

Hand wheel is buggered ,but I knew that when I bought it , could stick it back together and cast one ,canny job for a 3D printer  if I had one  Chin

[Image: P1100430_zpshuxrzqki.jpg]

I have a rectifier knocking about somewhere that I will add to it so I have a 0 to 270v DC option  , 


Rob
Reply
Thanks given by:
good one rob are you going to use it in your plating lab
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
(10-13-2015, 03:19 PM)krv3000 Wrote: good one rob are you going to use it in your plating lab

Aye for that and for a few other projects Bob  Big Grin  


Rob
Reply
Thanks given by:
Those are very handy devices. Nice score.

Ed
Reply
Thanks given by:
Useful bit of kit Thumbsup 
Smiley-eatdrink004 
DaveH
Reply
Thanks given by:
Rob, make sure your rectifier is rated at more than 380 volts. At an RMS voltage of 270, the peak voltage is 270 x 1.414 = 382 volts.
Mike

If you can't get one, make one.

Hawkeye, proud to be a member of MetalworkingFun Forum since Jan 2013.
Reply
Thanks given by:
(10-13-2015, 10:38 PM)Hawkeye Wrote: Rob, make sure your rectifier is rated at more than 380 volts. At an RMS voltage of 270, the peak voltage is 270 x 1.414 = 382 volts.

Hi Mike

I have a bag of 5      400v 30amp rectifiers some where  that I bought for a job a few years back .

Just can't fined the wee buggers  Chin  ...........probably will turn up 1 hour after I order some more  Slaphead


Rob
Reply
Thanks given by:




Users browsing this thread: 8 Guest(s)