MetalworkingFun Forum

C'mon Ed - it is time you finished this off...

(10-09-2015, 07:40 AM)Mayhem Wrote: [ -> ]C'mon Ed - it is time you finished this off...

I agree. I was just thinking about this project at work yesterday. I need to get the cocobola which I think I'll do today so I can finish it off. I also need to swap out the 17mm socket for the 3/4" to fit the new mill. I'm itching to do a project but with work and other stuff getting in the way, I've done little in the shop other than clean and organize, mostly clean/purge. It's starting to get old. Hmmm, just like me.  

Ed

You need to make a mess in order to clean it up Ed!

I looked through my small stack of exotic woods and found some pterocarpus soyauxii so I'm going to use that instead of dalbergia retusa. The additional secret adornment will not be named at this time.

Ed

Brass rings?

(10-10-2015, 11:33 PM)Vinny Wrote: [ -> ]Brass rings?

Not even close.

Ed

Gold plated hammer head! Inconel 718 hex socket! Engraved platinum name plate!

(10-15-2015, 02:33 PM)PixMan Wrote: [ -> ]Gold plated hammer head! Inconel 718 hex socket! Engraved platinum name plate!

Not even close either but nice try.

Ed

A pink ribbon  
 
DaveH

(08-21-2013, 08:36 AM)arvidj Wrote: [ -> ]Thor Hammers ... what a selection!!

I ran across this source for Thor hammers in the USA.

http://www.hammersource.com/Thor/

Ed