12-15-2013, 06:57 PM
12-15-2013, 08:00 PM
(12-15-2013, 06:57 PM)DaveH Wrote: [ -> ]A very nice job, David
DaveH
Thanks, I still have a couple little things left to do but basically they are finished
DA
12-15-2013, 08:16 PM
They turned out great, love the look of drill oilers, very classy.
12-16-2013, 05:09 AM
(12-15-2013, 08:16 PM)f350ca Wrote: [ -> ]They turned out great, love the look of drill oilers
When I made mine I used plastic pill containers. I didnt even cut the
bottom, just a large hole and used '0' rings. I used lawnmower carb.
jets for the drip. They work.
Edit: to fix quote tags
12-16-2013, 07:49 AM
was easier for me to copy the small one that I had been given then to re-engineer them. lot of people said to use plastic but I wanted glass for the look, plus the tubes were pretty cheap.
12-25-2013, 06:16 PM
(11-09-2013, 11:17 AM)dallen Wrote: [ -> ](11-09-2013, 09:55 AM)EdK Wrote: [ -> ]Nice job on the form tool David.
Ed
it should of been flat on top with no rake, but the bit was one that I had already used for something else and the side I turned up only had a slight negitive rake on it. It actually cut pretty good, I had it on center and would crank the cross slide in about 10 15 thousands and then run the carriage into the part to the depth that I needed, using lots of dark cutting oil.
(11-09-2013, 10:51 AM)DaveH Wrote: [ -> ]Coming a long nicely
DaveH
Dave, I've reached the point of needing the glass tube's, or I may just use some stainless steel tubing I have so I can call them done till I get the glass. They have actually been a lot easier to make then I had first thought they would be.
The one part that I haven't really figured out is the little cover over the filler hole as its spring loaded I may just put in a tube with a drop cap on it and a little chain or something to keep them from getting misplaced.
If you need to buy oiler glass, this is a real good source.
http://www.enginads.com/starbolt/
12-25-2013, 07:48 PM
12-26-2013, 07:56 AM
Dave,I betcha you would'nt have cracked a plastic sight "glass".
Sorry,
Sorry,
12-26-2013, 10:30 AM
Steve I betcha the glass ones don't discolor like most plastic's do
12-26-2013, 05:22 PM
(12-26-2013, 10:30 AM)dallen Wrote: [ -> ]Steve I betcha the glass ones don't discolor like most plastic's do
Or get as scratched or "fogged".
Nicely done Dallen.
-Ron