03-25-2014, 12:39 PM
My cin 16 shaper only has sprig loaded ball bearing oil holes to oil the ram slides.
Igot a figure out how to post pics of my mature collection then you guys can explain how to use them??
Scruffy Ron kincaid
Igot a figure out how to post pics of my mature collection then you guys can explain how to use them??
Scruffy Ron kincaid
(09-19-2012, 01:35 PM)stevec Wrote: [ -> ]rleete, Usually a mill table gets loose in the middle where most of the action occurs is there something about the mini mill that's different?
I had the vise on one side and the rotab on the other for a while but found that Murphy's law rules and you've gotta take one or the other of to clear some job.