11-30-2014, 02:53 PM
11-30-2014, 03:10 PM
(11-30-2014, 02:27 PM)dallen Wrote: [ -> ]know a guy that made one, hope you like cutting some really small gears.
I've never cut a gear so I guess it's better to screw up a bunch of small gears rather than large ones.
dallen Wrote:Will be watching for the thread.
DA
I wouldn't hold my breath waiting. It'll likely be next summer before I tackle that one. It's a very involved project so will be a good challenge.
Sorry to hijack your thread Tom.
Ed
12-04-2014, 07:08 PM
Tom,
I was wondering if there's an error in the drawing for the knurl holder? You list dimensions for the dowel holes as .250 +.000/-.001 thru and the other one as .250 +.001/-.001 to slot. I was wondering if the to slot should be .250 +.001/-.000?
Thanks,
Ed
I was wondering if there's an error in the drawing for the knurl holder? You list dimensions for the dowel holes as .250 +.000/-.001 thru and the other one as .250 +.001/-.001 to slot. I was wondering if the to slot should be .250 +.001/-.000?
Thanks,
Ed
12-04-2014, 07:34 PM
Hmmm, I thought I had that fixed, but it's fixed now.
Thanks for pointing it out Ed.
Tom
Thanks for pointing it out Ed.
Tom