04-29-2015, 10:57 AM
I suspect the extra HP goes into fast cycle times.
Fire Wood Processor
|
04-29-2015, 10:57 AM
I suspect the extra HP goes into fast cycle times.
04-29-2015, 12:27 PM
(04-29-2015, 10:57 AM)Roadracer_Al Wrote: I suspect the extra HP goes into fast cycle times. Probably right Al. Im slowing down so I guess the processor should match me.
Free advice is worth exactly what you payed for it.
Greg
04-30-2015, 06:18 AM
So basically, the saw is driven by a hydraulic motor with some increase of RPMs via jack shafts & pulley & belts.
![]() Steve ![]()
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
04-30-2015, 08:37 AM
(04-30-2015, 06:18 AM)stevec Wrote: So basically, the saw is driven by a hydraulic motor with some increase of RPMs via jack shafts & pulley & belts. No hydraulics will be used or harmed in the driving of the saw. It will be belt driven through an electric clutch to engage it.
Free advice is worth exactly what you payed for it.
Greg
04-30-2015, 07:51 PM
" no hydraulics" ? I give up!
![]() Steve ![]()
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
05-01-2015, 05:55 AM
Thought you said you needed to build a bender to make the hydraulic lines, no?
05-01-2015, 07:38 AM
(04-30-2015, 06:18 AM)stevec Wrote: So basically, the saw is driven by a (04-30-2015, 07:51 PM)stevec Wrote: " no hydraulics" ? I give up! Steve, I think the saw chain is being powered directly from the Wisconsin engine, via belts with an electric clutch in between. Everything else runs off of the hydraulics. If not, I give up too..... ![]()
Willie
05-01-2015, 08:59 AM
Willie has it right, the saw is belt driven , all the other functions are hydraulic.
Free advice is worth exactly what you payed for it.
Greg
05-01-2015, 07:01 PM
(05-01-2015, 07:38 AM)Highpower Wrote:(04-30-2015, 06:18 AM)stevec Wrote: So basically, the saw is driven by a
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
05-08-2015, 12:44 AM
The sprocket for the chain saw finally arrived, glad I didn't have a piece of equipment laid up waiting 9 weeks for parts.
Drilled and threaded the bolt pattern for the sprocket, a bit of creative clamping. Not well stocked with metric taps and dies, was rather amazed how well a Canadian Tire brand tap cut 4140. ![]() Then had to cut a keyway indexed to the bolt pattern. ![]() The keyway cut and it all fits, once in a while I get lucky. Even in the shop. ![]()
Free advice is worth exactly what you payed for it.
Greg |
« Next Oldest | Next Newest »
|