|
Setting Up My PM935 Mill
|
|
09-12-2015, 09:49 PM
I just figured that you didn't want the car to get lonely outside,
dallen, proud to be a member of MetalworkingFun Forum since Apr 2012.
If life seems normal, your not going fast enough! 
09-12-2015, 11:49 PM
With out a Mrs to direct, the shop is where ever you want it. Mine just happens to be bigger than the house and climate controlled. At least in the winter.
Free advice is worth exactly what you payed for it.
Greg
09-13-2015, 12:11 AM
(09-12-2015, 09:12 AM)arvidj Wrote:(09-12-2015, 07:13 AM)Mayhem Wrote:(09-11-2015, 05:48 PM)EdK Wrote: I got enough parameters set on the VFD to make the motor spin so there is some progress. I still have a few more I need to tweak and then I'll video the "running of the mill". Stay tuned. OK - how about this: Parameter one: Machine plugged in. Possible settings: (1) Yes, (2) No. Parameter two: 440V 32A three-phase power. Possible settings: (1) On, (2) Off. It took me a while to think about that
Hunting American dentists since 2015.
09-13-2015, 06:42 PM
A video as promised. Short and boring but it's all I had time for. This was a very busy weekend for me.
Ed
09-13-2015, 07:46 PM
That was pretty epic Ed
Free advice is worth exactly what you payed for it.
Greg Thanks given by: EdK
09-14-2015, 03:28 PM
One suggestion Ed. Find the parameter for carrier frequency and work on that. My ears still hurt!
Willie
09-14-2015, 04:04 PM
(09-14-2015, 03:28 PM)Highpower Wrote: One suggestion Ed. Find the parameter for carrier frequency and work on that. My ears still hurt! Yup, when I first turned it on I knew I had to adjust that first thing. The default is 2K and that's what you're hearing in the video. I bumped it up to 6K and that quieted it down quite a bit. I'll do some more tweaking once it's in its final resting place. Ed Thanks given by: Highpower
|
|
« Next Oldest | Next Newest »
|
