02-07-2016, 05:11 AM
I had expect this in response Rob:
![[Image: 200x200px-ZC-8d82e332_giving-the-finger-...oticon.gif]](http://cdn.stripersonline.com/8/8d/200x200px-ZC-8d82e332_giving-the-finger-smiley-emoticon.gif)
Hunting American dentists since 2015.
|
Latest Delivery
|
02-07-2016, 05:22 AM
Ha ha ha mint , I want one Darren
 , I NEED a link to that , pleeeeeeeeeeeeeeease ! Rob
02-07-2016, 05:23 AM
Hunting American dentists since 2015.
02-07-2016, 05:45 AM
Cheers Darren
![[Image: 200x200px-ZC-8d82e332_giving-the-finger-...7zgclc.gif]](http://s1066.photobucket.com/user/RobWilson100/media/Gifs/200x200px-ZC-8d82e332_giving-the-finger-smiley-emoticon_zpsdw7zgclc.gif.html) Rob
02-07-2016, 09:52 AM
Laughing myself silly here..
02-07-2016, 10:39 AM
Quiz: What is wrong with this picture? (I'll even thrown in a subtle hint...)
Willie
02-07-2016, 11:28 AM
I spotted it right away Willie. Did you put the old one back in or did you receive the incorrect bearings?
 Ed
02-07-2016, 11:30 AM
You have a big hole where the seal goes, exposing the marbles.
I finally had to change belt speeds on my mill/drill and found that some darn mice built a nest and peed all over the bearing. Apparently it's SEALED.
02-07-2016, 12:18 PM
(02-07-2016, 11:28 AM)EdK Wrote: I spotted it right away Willie. Did you put the old one back in or did you receive the incorrect bearings? I just wanted to get a picture of the inside of the drive housing before I started cleaning it out. All of the black crud in there is finely shredded v-belt material. Had the mill for several years now and I can't believe those bearings haven't crashed and burned. Not a drop of oil or grease to be found in them. They have been running dry the entire time.  I hadn't pulled the shaft out yet when I took the pic though. I did get the correct bearings (sort of). I ordered Timken bearings. I got boxes that say Timken on them. The bearings inside are marked Fafnir. (Japan)  But they are the correct size, with double seals, so that is what I'm using.
Willie
|
|
« Next Oldest | Next Newest »
|
Users browsing this thread: 6 Guest(s)