Drill Press Vise Modification
#1
A while back I had to drill some round disks (about 100), and the drill press vise really wasn't up to the task. Then I remembered a trick showed to me, by my grandfather (who ran a machine shop). I ended up drilling the vise jaws to accept tapered pins that hold the irregular shaped objects. I had some more of the disk to drill over last weekend and again the modification was very useful. As the disks are gone, I used a grinding disk as prop.


Attached Files Thumbnail(s)
               
jack
Reply
Thanks given by:
#2
Nice mod. I need to get a decent drill press vise. All I have is a cheapo cross vise. Smiley-signs131

Ed
Reply
Thanks given by:
#3
Good idea Jack Smile , cant get much more simple either ....another one on the 'to do list' Rotfl

Cheers Mick
Micktoon, proud to be a member of MetalworkingFun since Sep 2012.
Reply
Thanks given by:
#4
Jack,
Great idea ThumbsupWorthy
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#5
The simplest solutions are the bestThumbsupThumbsupThumbsup
John
Reply
Thanks given by:
#6
Great idea, thanks! Sadly the jaws on my vice are far too hard to drill ...
Arbalest, proud to be a member of MetalworkingFun since Sep 2012.
Reply
Thanks given by:
#7
Arbalest, are they removable? Maybe make a "soft" set?
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:
#8
Great idea Jack!!Thumbsup

Jerry.Popcorn
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#9
thats a good tip
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#10
That is a really neat idea. One of those "why didn't I think of that" ideas! Not only great for the drill press, but mill too. I know what I'll be doing tomorrow after work. Thanks for sharing.
pamrick, proud to be a member of MetalworkingFun since Jul 2012.
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)