a new compound slide
#1
hi all rob also gave me a compound slide off a myford 7 for me to convert in to a compound slide for my lathe this will be a long proses the first thing was to strip dawn the slide and give it a good clean sum pics


Attached Files Thumbnail(s)
           
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#2
I see your getting cracking Bob Thumbsup

Lets no if you need any material for the base Popcorn

Rob
Reply
Thanks given by:
#3
hi rob will do I'm thinking of a beater way to Locke the compound slide will post more pics tonight
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#4
hi all sum pics of bits bin panted then i set two on the slide i cut off the original fixing points of the slide then field them squire the compound is clamp by the means of a resest plate and two nuts locking the index ring to the Cross slide i am thinking of a other way to Locke this i will see as things go on i started to turn up Wat will be the index ring and the compound slide base right pics


Attached Files Thumbnail(s)
                               
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#5
Bob,

I see you borrowed Rob's shiny metal camera you lucky dog. Big Grin

Ed
Reply
Thanks given by:
#6
Looking good Bob
Shiney metal & blue paint
John
Reply
Thanks given by:
#7
Bob,

Not bad, not bad at all Smiley-signs107
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#8
Looken sharp Bob,Drool

Jerry.Popcorn
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#9
Nice work Bob!!!

I am sure it is going to make your compound rock solid!!!

Andrew
A proud member of MetalworkingFun Forum since Feb 2012.

1959 Myford ML7,1949 South Bend 9A,Clausing 8520 mill,Keller Die filer,1929 Rhodes Shaper.
Reply
Thanks given by:
#10
hi all i did a bit more tonight finished Wat will be the index ring and clamping ring the outer ring is 65mm the inner ring is 50mm with a 12.6mm reamed hole for the center pin with a 4mm internal step pics
krv3000, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:




Users browsing this thread: 2 Guest(s)