Hexy ER 32 Collet Holder
#1
Hi
I recently made a square collet holder
http://madmodder.net/index.php?topic=6804.0

Time for a hexy one
[Image: P3030065.jpg]
[Image: P3030061.jpg]

[Image: P3030062.jpg]

[Image: P3030068.jpg]
[Image: P3030071.jpg]
[Image: P3030078.jpg]

[Image: P3030084.jpg]
Bore the taper then put some threads on it tomorrowBig GrinBig GrinBig Grin
John
Reply
Thanks given by:
#2
Hi John,

So far so good Smiley-signs107

A nice bit of chamfering, what is the hole for?

Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#3
(03-03-2012, 05:48 PM)DaveH Wrote: Hi John,

So far so good Smiley-signs107

A nice bit of chamfering, what is the hole for?

Smiley-eatdrink004
DaveH

Hi
Dave
The hole is there in case i need to machine a hex on the end of a long bar SmileSmileSmileSmile
I bored it half way then broke in to it from the nose endBig GrinBig GrinBig Grin
John
Reply
Thanks given by:
#4
(03-03-2012, 05:53 PM)doubleboost Wrote: Hi
Dave
The hole is there in case i need to machine a hex on the end of a long bar SmileSmileSmileSmile
I bored it half way then broke in to it from the nose endBig GrinBig GrinBig Grin
John

Ah, Slaphead yes of course.

Smiley-eatdrink004
DaveH

Reply
Thanks given by:
#5
Hi
Had a full day in the shopBig GrinBig GrinBig Grin
Got my collet holder finished
[Image: P3040094.jpg]
[Image: P3040102.jpg]
[Image: P3040114.jpg]
Reply
Thanks given by:
#6
That looks nice John Worthy

I see you did some more chamferingSmile

A very nice jobSmile
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#7
Nice work John, Smiley-signs107

I would be interested to see how it is used. Big Grin

Jerry.Popcorn
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#8
(03-04-2012, 06:06 PM)ETC57 Wrote: Nice work John, Smiley-signs107

I would be interested to see how it is used. Big Grin

Jerry.Popcorn

Hi
Jerry
So would i Big GrinBig GrinBig GrinBig Grin
I used my square one to make a chuck key
The hex one will be good for one off bolt heads ect
Once it is set up in a mill vice you simply turn it over to put flats on to round bar
I will post some pictures of it in actionBig GrinBig GrinBig GrinBig Grin
John
Reply
Thanks given by:
#9
Thank's John ,

That would be great.Drool

Jerry.Popcorn
ETC57, proud to be a member of MetalworkingFun Forum since Feb 2012.
Reply
Thanks given by:
#10
Very handy items those collet blocks. Nice job on making yours. They should provide you years of service. Smiley-signs107

Ed
Reply
Thanks given by:




Users browsing this thread: 1 Guest(s)