Log Splitter
Dave,
I have the impression that the "flared" wedge would take MORE tonnage.
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:
   

Thanks Dave, now I remember Bash . How long I'll retain this is questionable though. Blush

Steve
Smiley-eatdrink004
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:
(01-20-2015, 09:50 AM)stevec Wrote: Dave,
I have the impression that the "flared" wedge would take MORE tonnage.

17428
All the flare does is help split the log by forcing it apart however it will only work once the log has started to split. If it doesn't start to split then that's it,....... no fire wood BashBawling

Smiley-eatdrink004
DaveH
Reply
Thanks given by:
Without a wedge you are actually cutting the wood lengthwise. The wedge does take more power but if you have enough power the wedge will speed up the cycle time because you won't have to use as much of the stroke to "split" the wood. Firewood processors don't use a wedge because the next round will push the previous wood on through the splitting axe.

As you all have mentioned there will be some of the stringy types that require a longer stroke to finish the split.
Reply
Thanks given by:
BF, interesting observation about how the pro's do it.

They must cut the wood into pieces just a little shorter than the stroke of the splitter. Push a piece thru and if it splits then fine but if it hangs up on the wedge or cutter then when the cylinder retracts there is enough room for the next piece to go behind is and just carry on.

Of course this assumes that stroke length is the limiting factor and not stroke force.
Reply
Thanks given by:
Without a wedge the cutting edge would need to be longer than the wood diameter. With stringy wood you could push a 6 inch cutting edge though a 12 inch block and not break it open.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:
Greg, not to be contentious but I have split 24" dia. wood with my 11" tall wedge.
Admittedly that size is usually trunk area wood and free of knots.

Steve

Smiley-eatdrink004
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:
I borrowed my friends gas powered splitter yesterday, and him for added labour. Even with its cast wedge (guess its about 2-3 inches wide) there were a few poplar that wouldn't split through. That wedge is about 6 inches tall with a neat feature, the cutting edge is angled slightly so that the top contacts first, would help hold the block down as it splits.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:
Greg, What sorta tonnage does your friends splitter develop? The poplar we have here splits if you look at it harshly. Rotfl  
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:
This is frozen right now, doesn't even saw great. The splitter goes through it easily just stringy.
Free advice is worth exactly what you payed for it.
Greg
Reply
Thanks given by:




Users browsing this thread: 8 Guest(s)