Need spec for indexable tool holder
#11
(05-26-2014, 12:24 PM)PixMan Wrote: Those are more commonly used in milling applications than turning. There are holders for turning with them, but if you already have a holder for SNMG43x size inserts (as I do) then you just need a different anvil (seat) and clamp. Most holders would use an eccentric screw in the middle and a clamp over the top. For those inserts you would switch to a screw-down anvil with no eccentric sticking up, and a flat clamp.

Once you have that, pray for the inserts. Big Grin

They are a non-reinforced Al²O³ ceramic insert, intended for milling cast iron. You would have an easier time finding a milling cutter that takes them. In fact, I may have one you could have for CHEAP.

PM me how cheap...
Chuck
Micromark 7x14 Lathe, X2 Mill , old Green 4x6 bandsaw
The difficult takes me a while, the impossible takes a little longer.
Reply
Thanks given by:




Users browsing this thread: 3 Guest(s)