Before and after, drill press vise.
#11
I wouldn't have thought to paint something like that in black as I would have thought it would not look too good. Its come up surprisingly well. Looks lovely.
Dont see a buttress thread much these days.
bollie7
bollie7, proud to be a member of MetalworkingFun Forum since May 2012.
Reply
Thanks given by:
#12
(09-12-2014, 01:32 AM)Shawn Wrote: I wasn't going to paint it at all when I first started but the paint was worse than it looked and it gave me a chance to try out the colour. I may paint a lathe flat black this winter so a test run was in order.

Excellent job Shawn, but I don't see how it's a test run for flat black, it sure looks like gloss to me.
( unless you too have a "shiny camera") Rotfl
Busy Bee 12-36 lathe, Busy Bee Mill drill, Busy Bee 4x6 bandsaw, Homemade 9x17 bandsaw, Ad infinitum.
Reply
Thanks given by:
#13
Your right Steve, it's not flat black it's Satin Black. I doubt I will use it again, I'm starting to have an affinity to plain old machine grey ?

Shawn
Shawn, proud to be a member of MetalworkingFun Forum since Nov 2013.
Reply
Thanks given by:
#14
Well I think it looks very smart Thumbsup
Smiley-eatdrink004
DaveH
Reply
Thanks given by:
#15
Makes me want to go repaint my motorcycle frame looks very sharp
bubby-joe, proud to be a member of MetalworkingFun Forum since Apr 2014.
Reply
Thanks given by:
#16
(10-16-2014, 02:24 PM)bubby-joe Wrote: Makes me want to go repaint my motorcycle frame looks very sharp

What make & model of motorbike? Is it a build in progress or something you'd have to disassemble?

BTW, welcome! ....from a fellow motorcyclist & machinist.
Reply
Thanks given by:




Users browsing this thread: